previous arrow
next arrow
Slider

SONAFLEX

Multipurpose Test Electronics Unit 

“SonaFlex” is a unique intelligent ultrasonic testing system with flexible hardware architecture. The basic Platform can easily be configured to generate all possible types of ultrasonic waves for various general purpose of specific lab and industrial applications.  The SonaFlex allows you to create relatively small NDT-systems or for performance of various lab tests.

“SonaFlex” is a unique intelligent ultrasonic testing system with flexible hardware architecture. The basic Platform can easily be configured to generate all possible types of ultrasonic waves for various general purpose of specific lab and industrial applications.  The SonaFlex allows you to create relatively small NDT-systems or for performance of various lab tests.

Typical Areas of Application :

  • Internal, surface and sub-surface defects detection;

  • Precise wall thickness measurement;

  • Material properties evaluation.

Type  of Applied Multichannel Ultrasonic or Eddy Current probes:

  • Non-contact EMAT array probes;

  • UT phase array probes;

  • UT probes with multiple piezo-crystals;

  • Eddy-current probes.

Basic Parameters of “SonaFlex”

  • SONAFLEX can be adjusted in order to achieve precise technical goals and fulfil the customer’s requirements:

  • Up to 3 frequencies within one unit ranging from 0.5 – 7.0 MHz;

  • Different types of sensors can be used for generation and receiving  acoustic signals over diverse parameters;

  • Up to 16 independent multiprocessing channels may be implemented;

  • Single – or multi-channel transducers based on EMAT or Piezo technology, singe element or phased array are applicable for the platform;

  • I.O.to external systems provided to allow easy integration.

EXAMPLES OF NDT SYSTEMS BASED ON SONAFLEX

RIDER
Set of Equipment for Mechanized Off-line Ultrasonic Examination of Plates, Strips, and Ingots

​The RIDER is a Manual Trolley System with our sophisticated, PC-based, and flexible SonaFlex platform. It examines quality of plates and slabs using ultrasonic waves (UT-test) and/or Eddy Current (EC-test) – according to all modern norms and standards.

EMATEST-WSP
Set of Equipment for Automatic Non-Contact Scarfing Quality Monitoring

EMATEST-WSP Scarfing Quality Monitoring System based on a state-of-the art EMAT NDT technology performs in-line inspecting of scarfing quality.  Scanning and building a profile of the scarfed surface, EMATEST-WSP can detect over/under scarfing, tool breakage or wear alarm operator when replacement of tool is required. Knowing the scarfing quality is required to maintain Weld line tolerances, which can effect product meeting requirements.
In many pipe mills, the first point at which the operator can observe scarfing quality is after the cut-off. This may result in large amounts of scrap, or expensive rework of the pipes, all preventable by using EMATEST-WSP

EMATEST-WTM
Set of Equipment for Mechanized  Non-Contact Ultrasonic Examination of Engines 

EMATEST – WTM is an ultrasonic thickness system designed to measure wall thickness on cylinders of combustion engines, even with different metal alloys during serial production.

The Main use of EMATEST – WTM is measuring the remaining wall thickness of cylinder sleeves, which are built in engine block for enhancement using Non-contact EMAT sensors to obtain precise measurement according to pre-set parameters.

EMATEST-EC
Automatic Non-Contact Ultrasonic Examination of Electronic Components

EMATEST-EC system is intended for automated ultrasonic non-contact testing of electronic components such as  multilayer ceramic capacitors, ferrite components and similar elements.